Setting up an IP filter

An IP filter restricts remote computer access, allowing incoming connections only from specified IP addresses and networks.

Accessing IP filter settings

Access the IP filter settings using Radmin Server options.

To access IP Filter settings:

Access Radmin Server options; a 'settings' window will appear ( illustration).

Server options window
Click on the Options... button to the display the 'Options' window.
Switch to the 'IP Filter' tab on the left ( illustration).

'IP Filter' server options window

Access IP filter settings and use the Enable IP Filter checkbox.

warning If the IP filter is enabled and no IP addresses or ranges are entered, it will be impossible to connect to the computer.

Configure the IP filter by adding and removing records from the list.

To add a record, click on the Add button; the 'Add IP address' window will appear ( illustration).

"Add IP Address" window

Enter the client's IP address or IP address range and click the Add button.
To remove a record, select the target record and click the Remove button.